WARNING
!
To avoid risk of electrical shock, personal injury, or death,
disconnect electrical power and shut-off gas supply to
unit before servicing.
Disassembly Procedures
24
16022514 Rev. 0
© 2004 Maytag Services
Oven Burner Ignitor
1. Shut off electrical power and gas supply to oven.
2. Remove oven door and oven racks.
3. Remove oven bottom by sliding locking tabs to the
front and lifting the rear. Then sliding the oven bottom
back to release clips on the front edge.
4. Remove screws securing ignitor bracket to back
burner box. Remove screw securing ignitor to bake
burner.
5. Pull ignitor leads and connectors through opening.
Disconnect ignitor wiring.
6. Reverse procedures to reassemble.
Oven Burner
1. Shut off power and gas supply to oven.
2. Remove oven door and oven racks.
3. Remove oven bottom by sliding locking tabs to the
front and lifting the rear. Then sliding the oven bottom
back to release clips on the front edge.
4. Remove screw securing ignitor to bake burner.
5. Remove screws securing orifice cover to the bottom of
the oven.
6. Remove screws securing front and rear of the bake
burner.
7. Lift and remove bake burner from the oven cavity.
8. Reverse procedures to reassemble.
Pressure Regulator / Shut-Off Valve
1. Turn off and disconnect electrical and gas supplies to
the oven.
2. Remove screws securing lower vent cover to side trim
pieces.
3. Disconnect gas line from the pressure regulator.
4. Disconnect gas supply line from the shut-off valve.
5. Remove screws securing mounting bracket to oven
chassis.
6. Remove mounting bracket with shut-off valve and
pressure regulator from unit.
7. Disconnect pressure regulator from shut-off valve.
8. Replace failed component and reverse procedures to
reassemble.
NOTE:
Use a soap solution to check for leaks after
installing replacement regulator.
Gas Valve
NOTE:
Requires removal of unit from cutout opening.
1. Turn off power to the unit at the circuit breaker.
2. Remove oven door, see “Door Removal” procedure.
3. Remove screws securing wall oven to cabinet.
4. Remove unit from cutout position and place on a
protective surface.
5. Remove screws securing back cover to chassis and
remove.
6. Disconnect gas lines to and from gas valve.
7. Disconnect and label wire terminals from gas valve.
8. Reverse procedure to reinstall oven door hinge
assembly.
