WARNING
!
Disassembly Procedures
© 2004 Maytag Services
16022514 Rev. 0
23
To avoid risk of electrical shock, personal injury, or death,
disconnect electrical power and shut-off gas supply to
unit before servicing.
Oven Door Hinge
NOTE:
Requires removal of unit from cutout opening.
1. Turn off power to the unit at the circuit breaker.
2. Remove oven door, see “Door Removal” procedure.
3. Remove screws securing wall oven to cabinet.
4. Remove unit from cutout position and place on a
protective surface.
5. Remove screws securing back cover to chassis and
remove.
6. Remove screws securing top cover to chassis and
remove.
7. Remove screws securing appropriate side body panel
to chassis and remove.
8. Remove screw securing side insulation retainer to rear
of oven chassis.
9. Grasp upper back portion of the side insulation
retainer and pull outward to remove.
10. Remove the top and bottom screws securing hinge
assembly to the front of the oven cavity.
11. Remove the hinge assembly from the unit.
12. Reverse procedure to reinstall oven door hinge
assembly.
Blower Motor
1. Remove control panel assembly, see “Control Panel
Assembly” procedure steps 1 through 3.
2. Remove screws securing blower assembly to fan
housing.
3. Disconnect terminal plug from blower assembly.
4. Remove blower assembly from unit.
5. Reverse procedure to reassemble.
Vent Assembly
1. Turn off electrical power and gas supplies to the oven.
2. Open oven door or remove oven door.
3. Remove screws securing unit to the wall.
4. Remove unit from cutout opening.
5. Disconnect electrical power and gas supply line to
unit.
6. Remove screws securing top cover to the unit.
7. Remove screws securing vent assembly to unit.
8. Remove screws securing fan housing to unit.
9. Remove screw securing duct assembly riser to oven
vent.
10. Remove vent assembly from oven vent.
11. Reverse procedure to reassemble.
Broil Ignitor
1. Shut off power and gas supply to oven.
2. Remove oven door and oven racks.
3. Remove screw securing broil ignitor wire cover and
remove cover.
4. Remove screw securing front of broiler burner to the
front of oven cavity.
5. Remove broil ignitor mounting screws.
6. Pull ignitor leads and connectors into oven cavity
through hole in broil chamber.
7. Disconnect ignitor wiring.
8. Reverse procedures to reassemble.
Broil Burner
1. Shut off electrical power and gas supply to oven.
2. Remove oven door and oven racks.
3. Remove screw securing front of broiler burner to the
front of oven cavity.
4. Remove broiler burner from orifice holder.
5. Remove broil ignitor mounting screws. Remove ignitor
from broiler burner.
6. Remove wing nut securing flame spreader to broiler
burner.
7. Reverse procedures to reassemble.
