Jema JM-988, Manual Book

Page: 12 / 18

11
Fig. (13) After the Sensor Installation
Installation method:
attaching machine until sensor light is on (Fig. 13) and sensor is not touched by trimming
iron (Fig. 14).
Dismantle the shell behind button attaching machine (Fig. 12), fix the sensor on button
Fig. (14) After the Sensor Installation
JACK and ZOJE split machine
Installation Position of Induction Fixing Support
Fig. (15) Before Installation Fig. (16) After the Sensor Installation
Installation method:
connecting rod, install button attaching machine sensor in screw hole, adjust the sensor
and connecting rod until the spacing is 0.5mm (sensor light is on), as shown in Fig. (16).
Notes: Don't touch sensor for fear of any damage.
Behind the nailcatcher machine shell down first (Fig.15), bottom out the trimming
Position for install the sensor(373D)
Fig.17 Before the 373D sensor is installed
Factory installed
Fig.18