Jeep Grand Cherokee, Operating Information Manual

Page: 50 / 315

NOTE:
When using the ISOFIX attaching system to
install a child restraint, please ensure that
all seat belts not being used for occupant
restraints are stowed and out of reach of
children. Remind all children in the vehicle
that the seat belts are not toys and should
not be played with, and never leave your
child unattended in the vehicle.
The two outboard rear seating positions have
anchorages, child seats with fixed lower at-
tachments must be installed in the outboard
positions only. Regardless of the specific type
of lower attachment, never install ISOFIX-
compatible child seats such that two seats
share a common lower anchorage.
If you are installing ISOFIX-compatible child
restraints in adjacent rear seating positions,
you can use the ISOFIX anchors or the vehi-
cle’s seat belt for the outboard position, but you
must use the vehicle’s seat belt at the center
position. If your child restraints are not ISOFIX-
compatible, you can only install the child re-
straints using the vehicle’s seat belts. Please
refer to “Installing The ISOFIX-Compatible
Child Restraint System” for typical installation
instructions.
Installing The ISOFIX-Compatible Child
Restraint System
We urge you to carefully follow the directions of
the manufacturer when installing your child
restraint. Not all child restraint systems will be
installed as described here. Again, carefully
follow the installation instructions that were pro-
vided with the child restraint system.
The rear seat lower anchorages
are round bars, located at the rear
of the seat cushion where it meets
the seatback, and are just visible
when you lean into the rear seat to
install the child restraint. You will
easily feel them if you run your finger along the
intersection of the seatback and seat cushion
surfaces.
In addition, there are top tether strap anchor-
ages behind each rear seating position located
on the back of the outboard seats.
Latch Anchorages
Tether Strap Routing
46