Jeep Grand Cherokee, Operating Information Manual

Page: 19 / 315

CAUTION!
Always remove the Sentry Keys
姞
from the
vehicle and lock all doors when leaving the
vehicle unattended.
At the time of purchase, the original owner is
provided with a four-digit Personal Identifica-
tion Number (PIN). Keep the PIN in a secure
location. This number is required for replace-
ment of keys. Duplication of keys consists of
programming a blank key to the vehicle elec-
tronics. A blank key is one which has never
been programmed. See your authorized dealer
if you require replacement or additional keys for
your vehicle.
NOTE:
When having the Sentry Key
姞
Immobilizer
System serviced, bring all vehicle keys with
you to an authorized dealer.
Customer Key Programming
See your authorized dealer if you require re-
placement or additional keys for your vehicle.
General Information
The Sentry Key
姞
Immobilizer is a 433.92 MHz
system. It will be used in the following Euro-
pean countries, which apply Directive 1999/5/
EC: Austria, Belgium, Czech Republic, Den-
mark, Finland, France, Germany, Greece,
Hungary, Ireland, Italy, Luxembourg, Nether-
lands, Norway, Poland, Portugal, Romania,
Russian Federation, Slovenia, Spain, Sweden,
Switzerland, Yugoslavia, and United Kingdom.
•
This device may not cause harmful interfer-
ence.
•
This device must accept any interference
that may be received, including interference
that may cause undesired operation.
VEHICLE SECURITY ALARM — IF
EQUIPPED
The Vehicle Security Alarm monitors the vehicle
doors, liftgate and hood for unauthorized entry
and ignition for unauthorized operation.
If something triggers the alarm, the Vehicle
Security Alarm will sound the horn intermit-
tently, turn on the headlights and flash the turn
signals/side repeaters and the Vehicle Security
Light in the cluster.
Rearming Of The System
If something triggers the alarm, the Vehicle
Security Alarm will signal with the siren for
30 seconds. If the triggering device is not
deactivated the siren will sound again after a
five second delay for another 30 seconds. If the
trigger remains present this cycle will repeat for
up to five minutes.
To Arm The System
1. Remove the key from the ignition switch and
exit the vehicle.
2. Lock the doors and liftgate by pressing the
power door LOCK switch or the LOCK button
on the Remote Keyless Entry (RKE) transmitter.
NOTE:
The Vehicle Security Alarm will not arm if
you lock the doors with the manual door
lock plungers or the driver’s door lock cyl-
inder.
3. Close all the doors.
15