Jeep Grand Cherokee, Operating Information Manual

Page: 138 / 315

•
Personal Settings Not Avail – Vehicle in Mo-
tion — manual transmission
•
Door Ajar (with vehicle graphic showing
which door is open. A single chime sounds if
the vehicle is in motion).
•
Doors Ajar (with vehicle graphic showing
which doors are open. A single chime
sounds if the vehicle is in motion).
•
Gate (with vehicle graphic showing the Lift-
gate open and A single chime).
•
Low Tire Pressure (with a single chime).
Refer to “Tire Pressure Monitoring System” in
“Starting And Operating”.
•
Check TPM System (with a single chime).
Refer to “Tire Pressure Monitoring System” in
“Starting And Operating”.
•
Check Gascap (refer to “Adding Fuel” in
“Starting And Operating” for more details)
•
Service Park Assist System (with a single
chime)
•
Oil Change Required (with a single chime)
•
ECO (Fuel Saver Indicator) — if equipped
Oil Change Required
Your vehicle is equipped with an engine oil
change indicator system. The “Oil Change Re-
quired” message will flash in the EVIC display
for approximately 10 seconds after a single
chime has sounded to indicate the next sched-
uled oil change interval. The engine oil change
indicator system is duty cycle based, which
means the engine oil change interval may
fluctuate dependent upon your personal driv-
ing style.
Unless reset, this message will continue to
display each time you turn the ignition switch to
the ON position. To turn off the message tem-
porarily, press and release the FUNCTION SE-
LECT button. To reset the oil change indicator
system (after performing the scheduled main-
tenance), perform the following procedure:
1. Turn the ignition switch to the ON position.
Do not start the engine .
2. Fully depress the accelerator pedal slowly
three times within 10 seconds.
3. Turn the ignition switch to the LOCK posi-
tion.
NOTE:
If the indicator message illuminates when
you start the vehicle, the oil change indica-
tor system did not reset. If necessary, repeat
this procedure.
Trip Functions
Press and release the MENU button until one of
the following Trip Functions displays in the
EVIC:
•
Average Fuel Economy
•
Distance To Empty
•
Elapsed Time
•
Display Units of Measure in
Press the SCROLL button to cycle through all
the Trip Computer functions.
The Trip Functions mode displays the following
information:
•
Average Fuel Economy
Shows the average fuel economy since the last
reset. Average Fuel Economy can be reset by
pressing and holding the SELECT button (as
prompted in the EVIC display). Upon reset the
history information will be erased, and the
134