Jeep 2012 Compass, Owner'S Manual

Page: 167 / 497

4. Continue to hold both buttons and observe the indi-
cator light. The Homelink
威
indicator will flash slowly
and then rapidly after Homelink
威
has received the fre-
quency signal from the hand-held transmitter. Release
both buttons after the indicator light changes from slow
to rapid.
5. Press and hold the programmed HomeLink
威
button
and observe the indicator light.
•
If the indicator light stays on constantly, program-
ming is complete and the garage door/device
should activate when the HomeLink
威
button is
pressed.
•
To program the two remaining HomeLink
威
buttons,
repeat each step for each remaining button. DO
NOT erase the channels.
Reprogramming A Single HomeLink
威
Button
To reprogram a channel that has been previously trained,
follow these steps:
1. Turn the ignition switch to the ON/RUN position.
2. Press and hold the desired HomeLink
威
button until
the indicator light begins to flash after 20 seconds. Do not
release the button.
3.
Without releasing the button
proceed with “Program-
ming A Non-Rolling Code” Step 2 and follow all remain-
ing steps.
Canadian/Gate Operator Programming
For programming transmitters in Canada/United States
that require the transmitter signals to “time-out” after
several seconds of transmission.
Canadian radio frequency laws require transmitter sig-
nals to time-out (or quit) after several seconds of trans-
mission – which may not be long enough for HomeLink
威
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165