Jeanneau SUN ODYSSEY 49 DS, Owner'S Manual, Page: 89 / 126

85/122
USE OF MARINE HEADS EQUIPPED WITH A WASTE HOLDING TANK (WHT) -
OPTIONAL EXTRA
There are two different types of WHT: The simple tanks (Fig. 1) and the tanks equipped with 3 way
valves (Fig. 2).
Open the water intake valve (ref. 1) (valve handle parallel to the pipe).
In the case of a direct discharge into the sea:
- Fig. 1: Open the draining valve (ref. 2).
- Fig. 2: Close the access to the tank with the 3 way valve (ref. 6). Open the draining valve (ref. 7).
In case you store the waste waters in the tank:
- Fig. 1: Make sure the draining valve is closed (ref. 2) (valve handle perpendicular to the pipe).
- Fig. 2: Make sure the draining valves are closed (ref. 2, 7) (valve handle perpendicular to the pipe).
Open the access to the tank with the 3 way valve (ref. 6).
To drain the bowl, set the control lever of the pump slantwise (FLUSH) then operate the pump.
To dry the bowl, set the lever vertical (DRY) then operate the pump.
In order to avoid clogging the heads:
- Use absorbent paper exclusively.
- Schedule a regular rinsing through of the system with fresh water.
WARNING
Tanks nominal load capacity cannot be fully used based due to trim and boat loading. A 20% reserve
should be kept..
WARNING
Ask for information about the laws in force in your country or your marina about discharging your
waste waters into the sea.
PRECAUTION
Close the valves after each use and above all when the boat is unattended.
7
PLUMBING