- 104 -
15.4 LAUNCH/LIFT OUT
The initial commissioning of your boat will require a lot of skill and care. The proper working of
all your boat's equipment is the result of the quality of the commissioning operations. This is
why the initial launch must be overseen by your dealer.
Before launching
- Replace the log in its housing.
- Check the cleanliness of the sea water strainers.
- Check the anodes (see the chapter on Electricity).
- Check the propeller (see the chapter on Steering).
- Prepare enough fenders and lines.
- Check the opening of the fuel supply tap (see the chapter on motorisation).
Do not remain onboard or beneath the boat during the handling operations.
- When placing the slings make sure that the positioning marks are still visible.
- Submerge the sling fully under the engine mounting.
Towing ring
(used only for towing purposes)
Summary of Contents for CAP CAMARAT 7.5 WA series 2
