Chapter 8
Measure Mode – Basic Tab
Tilt
172
DSAM Help User Guide
Rev. 001
8
Using the arrow keys and the
Select
softkey, select up to
twelve
channels
for tilt measurement.
9
Press the
Done
softkey.
10
Press the
Done
softkey.
Setting High and
Low Pilot
Channels
To set the high and low pilot channels
1
To move the marker horizontally to the low pilot channel, use the
left and right arrow keys
.
2
Press the
Markers
softkey.
3
Using the arrow keys, select
Low
.
If the marker is on a channel that is the high pilot or is greater in
frequency than the high pilot,
Low
is disabled.
4
Press
ENTER
.
5
To move the marker horizontally to the high pilot channel, use the
left and right arrow keys
.
6
Press the
Markers
softkey.
7
Using the arrow keys, select
High
.
Figure 156
Measure Mode – Select Tilt Channels
NOTE
You can also change the channels in the channel plans from
21128026 R001 DSAM Help User Guide.book Page 172 Thursday, February 5, 2009 2:02 PM
