JCB, SO53 3LE
www.JCBDIY.com
Customer Helpline 0333 0143092
WORKING HINTS FOR YOUR BELT SANDER
If your power tool becomes too hot, especially when used at low speed, set the
speed to maximum and run with no load for 2-3 minutes to cool the motor. Avoid
prolonged usage at very low speed. Always use a sanding belt suited to the
material you wish to sand. Always ensure the work-piece is firmly held or clamped
to prevent movement. Support large panels close to the sanding area. Any
movement of the material may affect the quality of the sanding finish. Start your
sander before sanding and turn off only after stopping sanding. For best results
sand wood in the direction of the grain. Do not start sanding without the sanding
belt fitted. Empty the dust bag every 5 minutes or sooner to ensure efficient dust
collection.
MAINTENANCE
Remove the plug from the socket before carrying out any adjustment, servicing
or maintenance.
Your power tool requires no additional lubrication or maintenance. There are no user
serviceable parts in your power tool. Never use water or chemical cleaners to clean
your power tool. Wipe clean with a dry cloth. Always store your power tool in a dry
place. Keep the motor ventilation slots clean. Keep all working controls free of dust.
Occasionally you may see sparks through the ventilation slots. This is normal. If the
supply cord is damaged, it must be replaced by the manufacturer, its service agent or
similarly qualified persons in order to avoid a hazard.
ENVIRONMENTAL PROTECTION
Waste electrical products should not be disposed of with household waste.
Please recycle where facilities exist. Check with your local authorities or retailer
for recycling advice.
