Follow these steps to install or replace the Vitroceram glass in fixed panels of a Lea 998 fireplace:
( N.B. -- For a new installation, start at step 6 and always use protective gloves to handle glass.)
1. Remove the 3 screws holding the glass upper shield and remove the shield.
2. Loosen the four M4 screws.
3. Remove the clamps holding the glass panel in the frame.
4. Recuperate the rubber insulators.
5. To avoid injury, use protective gloves with extreme care to remove the broken glass.
6. Slide the new glass into the frame and fasten it in place with the clamps and rubber insulators.
7. Install the four M4 screws (new installation) or retighten the four M4 screws when replacing.
8. For new installation, install the glass upper shield and the three screws holding it.
9. During replacement, reinstall the glass upper shield and the three screws holding it.
NOTE: Never use substitute parts. Use only Bordelet brand parts.
2.4.6 Glass Care-Cleaning
1. Keep the glass relatively clean. Dirty glass doors and fixed panels will make the fireplace
overheat. Wait until the glass is cool before attempting to clean it. Wash the glass with window or
oven cleaner, dishwashing liquid or just soap and water. Spray the cleaner on a soft cloth and not
on the glass, since overspray may discolor the painted finish (not covered by the warranty). DO NOT
use steel wool, soap pads (S.O.S.) or any other abrasive product since these may scratch the glass.
2.4.7 Dealing with a Chimney Fire
Regular chimney maintenance and inspection can prevent chimney fires. If a chimney fire occurs,
follow these steps:
1. Keep the fireplace doors closed and close the combustion air control;
2. Alert your family to the possible danger and move them to safety;
3. Call the local fire department immediately;
4. If possible, use a dry chemical fire extinguisher, baking soda or sand to control the fire.
Do not use water as it may cause a dangerous steam explosion
;
Page 18
Installation and replacement of Vitroceram glass in fixed panel.
1) Remove the 3 screws holding upper shield
and remove shield.
2) Loosen 4 x M4 screws
3) Remove clamps holding glass.
4) Recuperate rubber insulators.
5) Remove broken glass with care.
6a) Slide new glass into frame.
6b) Fasten new glass with
clamps and rubber insulators.
7) Retighten 4 x M4 screws.
8) Reinstall glass upper shield
& 3 screws holding it.
Summary of Contents for LEA 998 CFF
Page 7: ...Page 7...
Page 8: ...Page 8...
