20
FNS-0012-060-EN June 2019 Rev A
6. Remove
juicing
components (see Figure 6).
a. Cups should be separated. (Juicer should have been turned off using the STOP
button on the touch screen, see Step 1.)
b. Remove reservoir and juice nozzle, then lift splash shield off mounting brackets.
CAUTION:
DO
NOT
PLACE
HANDS
OR
FINGERS
BETWEEN
CUPS.
c. Grasp upper cup and pull out pin just above it. Place upper cup in waste
container.
d. Using spanner tool and starting at bottom, loosen the strainer tube in manifold,
manifold spanner screw and the spanner nuts securing the lower cup.
CAUTION: CUTTER AND KNIVES ARE SHARP.
e. Install red protective cap on cutter.
(Red protective cap is provided.)
f.
Grasp juice manifold and orifice tube firmly. Remove entire juicing components
assembly.
g. Grasp orifice tube and pull out of strainer tube.
h. Remove strainer tube from inside juice manifold by turning tube counter-clockwise
and sliding out. (Spanner wrench is provided to loosen/tighten strainer tube.)
Place juicing components into waste container.
7. Prepare cleaning solution.
Read the product label on Cleaning Solution and follow the manufacturer's mixing
directions and safety precautions.
8. Immerse all components in cleaning solution.
Use the blunt end of plastic rod provided to displace any fruit material lodged in the
bore of the orifice tube.
Use pointed end of plastic rod to displace any fruit material lodged in cup fingers.
9. Scrub components.
Use a brush, towel, or sponge.
DO NOT
use abrasive pads such as steel wool.
Thoroughly rinse with clean water, then thoroughly rinse with sanitizer solution.
Follow the manufacturer's mixing directions and safety precautions.
10. For best results, soak strainer tube overnight.
After soaking overnight, rinse the strainer tube thoroughly before using. Check that all
strainer tube holes are clean. Clean strainer tube with a hard spray from a hose
while moving orifice tube back and forth in strainer tube. Rinse thoroughly with
sanitizer solution. Allow to air dry.
Summary of Contents for Fresh'n Squeeze 2nd Generation Multi-Fruit...
