36
FNS-0012-060-EN June 2019 Rev A
Troubleshooting (continued)
•
Juicer stalls trying to squeeze fruit
1. Fruit has part of stem on it.
Turn off Juicer and unplug . Remove fruit from the Juicer and restart.
2. Peel is too thick.
Turn off Juicer and unplug. Remove fruit from the Juicer and restart.
3. Juicer is operating too quickly.
Use a lower speed setting on the settings page.
4.
Turn off Juicer and unplug . Remove fruit from the Juicer and restart.
5. Cutter is damaged.
CAUTION: CUTTER AND KNIVES ARE SHARP.
a. Sharpen or replace cutter as specified in Maintenance section.
b. Install red protective cap onto cutter.
c. After red protective cap is installed, remove cutter. Handle cutter with care to avoid contact
with sharp edge.
•
Juicer runs with covers open or off
Power off and unplug juicer Immediately and call service provider
•
Juicer emits "squealing" sound during operation
Spray food grade lubricant on all rotating parts.
If noise continues, call service provider. Grease fittings may need to be lubricated or rod end or
bearings may need to be replaced.
•
Scraping noise coming from hopper area
Fruit lift mechanism is dragging on hopper.
Call Service Provider
NOTE: IF AN OPERATIONAL PROBLEM PERSISTS AFTER TROUBLESHOOTING,
CONTACT YOUR SERVICE PROVIDER FOR ASSISTANCE.
Summary of Contents for Fresh'n Squeeze 2nd Generation Multi-Fruit...
