ENGLISH
USER MANUAL
JB SYSTEMS®
16/87
PARTY BAR
22
000-004
Blackout
Green Laser
005-009
ON
010-255
Strobe speed
(slow to fast)
23
000-004
Stop
Laser Motor
005-127
Clockwise rotation
128-133
Stop
134-255
Anticlockwise rotation
White Flash Led Control
24
000-004
Blackout
Led 1
005-009
Full on
010-255
Strobe Speed
(slow to fast)
25
000-004
Blackout
Led 2
005-009
Full on
010-255
Strobe Speed
(slow to fast)
26
000-004
Blackout
Led 3
005-009
Full on
010-255
Strobe Speed
(slow to fast)
27
000-004
Blackout
Led 4
005-009
Full on
010-255
Strobe Speed
(slow to fast)
Extra functions in the menu
Press the [MENU] button until the display shows [SYS].
Press the [ENTER] button if you want to enter this part of the menu with extra options.
Use the [UP/DOWN] buttons to browse the extra functions in this System menu
o
[AddS] gives you the opportunity to change the command position of the 4 RGB projectors
Press the [ENTER] button to enter the option settings
The position of the first projector will blink
Press the [UP] button to go the projector that needs its position to be changed
Press the [DOWN] button to change the position number of the projector
Press again the [UP] button if want to change the position number of another
projector
Repeat these steps as much as needed
When all your settings are done, press the [ENTER] button to confirm your settings.
IMPORTANT:
if you set a wrong combination (same projector number selected several times) some
projectors might not work anymore.
If a projector does not work, first check if the command position is correct.
STANDARD= 1-2-3-4
IMPORTANT:
if you set a wrong combination (same projector number selected several
times) some projectors might not work anymore.
If a projector does not work, first check if the command position is correct.
STANDARD= 1-2-3-4
o
[LEdS] with this option you can decide if the display should be always on or if it can go out
after a while when no new information needs to be shown
Press the [ENTER] button to enter the option settings