40
VTX A
8
| Rigging Manual
STEPS:
• With the front QRPs set, use the electric hoist to raise the array. Be aware that the second cluster may swing forward slightly
as it lifts off the ground.
• Once the array is off the ground, grab the lower cluster by the rear VT handlebar (on the bottom) and gently pull back towards
the rear of the array. While doing this, lower the array so that the front wheels of the VT touch the ground. Keep lowering the
array until the rear attachment points engage and then insert the two rear QRP’s.
• Once all four QRP’s have been secured, lift the array off the ground and remove the VT.
In some cases, the angle of the flown array is too steep to fully connect to the cluster on the ground. This can happen when assembling
large arrays or when the frame pick-point is too far back as shown in the example below. In this situation, a two-step process is used to
connect all four connection points of the array.
1
2
3
1
2
2
