JBL PROCRISTAL i 30, Original Operating Instructions

Page: 12 / 80

8
Parts and description:
1. Pump head
2. Impeller
3. Euro plug with cable
4. Container for cartridges: SuperClear, GreenStop or AlgaePrevent
5. Rotatable water outlet with air injection nozzle and
fl ow control
5a. O-ring
6. Hose for air inlet
6a. Dummy cap for air inlet (as-delivered condition)
7. Cartridge: SuperClear (as-delivered condition), GreenStop or AlgaePrevent
8. Module (scope of delivery: 1 module)
9. Filter sponge 30 ppi for
fi lter module
10. Base plate
11. Suction cups
Operating instructions:
1. Remove the base plate
D
. Remove the fi lter sponge
R
and rinse it brie fl y under run-
ning tap water.
2. Activate the fi lter sponge with JBL FilterStart cleansing bacteria: Depending on the ap-
plication pour 30 – 50 drops JBL NanoFilterStart or JBL FilterStart Red directly on to the
fi lter sponge. Insert the fi lter sponge back into the module
L
and reposition the base
plate
D
again.
3. Remove the separately enclosed SuperClear cartridge X from its foil and rinse it brie fl y
under running tap water.
4. Pull the water inlet
W
upwards to remove it and insert the SuperClear cartridge
X
into its container
U
.
5. Mount the suction cups V with a turn into the intended fi xing holes.
6. If desired, the cap
\$
can be removed to insert the hose
\
into the opening of the
air inlet. The escaping water fl ow then also automatically sucks in air.
7. Clean the aquarium pane where the fi lter is to be positioned and press it with the suc-
tion cups against the pane. The water outlet should be located about 2 cm under the
water surface.
8. Connect the fi lter to the power supply. Adjust the water amount supplied by turning
the water outlet t or -. Turning the ribbed ring adjusts the water outlet in the
direction you want without changing the
fl ow rate.
9. The mechanical-biological fi lter capacity can be increased by the purchase of up to 3
(depending on the aquarium height) fi lter modules
L
.