-1-
INTRODUCTION
Your new Jackson Building Centres worktop jig
will more than satisfy your expectations. It has
been manufactured under stringent Quality
Standards to meet superior performance criteria.
CAUTION: Carefully read through this entire
Instruction Manual before using your new jig.
Take special care to heed the warning symbols.
TECHNICAL DATA
Jig thickness
10mm
Cutter size
12.7mm
Workpiece thickness max.
45mm
Worktop width:
min.
600mm
max.
616mm
Guide bush size
30mm
Weight
6.1kg
CONTENTS
TECHNICAL DATA _____________________1
SAFETY ____________________________2-3
ITEMS ENCLOSED ____________________4
DESCRIPTION OF PARTS _______________4
ACCESSORIES
– Recommended Cutters
________________5
– Sub-base Set
________________________5
– Panel Butt Connector Bolts
_____________6
– Biscuit Jointer for the Router
____________6
– Flat Biscuit Dowels
____________________6
– Clamp
______________________________6
ASSEMBLY
– Location Bush Identification
_____________7
– Margin Distance
______________________7
– Setting out the Joints
__________________7
OPERATION
– Setting the Length Stop _______________
8
– Female Joint_________________________
8
– Male Joint___________________________
9
– Cutting the Bolt Recesses _____________
10
– Strengthening the Joint _______________
11
– Sealing the Joint ____________________
11
SPARE PART ________________________11
MAINTENANCE ______________________11
ENVIRONMENTAL PROTECTION ________11
TROUBLESHOOTING _________________12
GUARANTEE ________________________IB
The following symbols are used throughout this
manual:
Denotes risk of personal injury, loss of
life or damage to the tool in case of non-
observance of the instructions in this
manual.
Refer to the instruction manual of
your power tool.
This unit must not be put into service until it has
been established that the power tool to be
connected to this unit is in compliance with
98/37/EC (identified by the CE marking on the
power tool).
INTENDED USE
This jig is intended for use with a plunge router
with suitable guide bush and router cutter fitted
to rout a kitchen worktop joint in laminate
covered particle board.
