ENGLISH
USER MANUAL
JB SYSTEMS
®
11/75
SMOOTH SCAN-3 LASER
Pattern list
ENGLISH
USER MANUAL
JB SYSTEMS
®
12/75
SMOOTH SCAN-3 LASER
MAINTENANCE
Make sure the area below the installation place is free from unwanted persons during servicing.
Switch off the unit, unplug the mains cable and wait until the unit has been cooled down.
During inspection the following points should be checked:
All screws used for installing the device and any of its parts should be tightly fastened and may not be
corroded.
Housings, fixations and installations spots (ceiling, truss, suspensions) should be totally free from any
deformation.
When an optical lens is visibly damaged due to cracks or deep scratches, it must be replaced.
The mains cables must be in impeccable condition and should be replaced immediately when even a
small problem is detected.
In order to protect the device from overheat the cooling fans (if any) and ventilation openings should be
cleaned monthly.
The interior of the device should be cleaned annually using a vacuum cleaner or air-jet.
The cleaning of internal and external optical lenses and/or mirrors must be carried out periodically to
optimize light output. Cleaning frequency depends on the environment in which the fixture operates: damp,
smoky or particularly dirty surroundings can cause greater accumulation of dirt on the unit’s optics.
Clean with a soft cloth using normal glass cleaning products.
Always dry the parts carefully.
Clean the external optics at least once every 30 days.
Clean the internal optics at least every 90 days.
Attention: We strongly recommend internal cleaning to be carried out by qualified personnel!
SPECIFICATIONS
Mains Input:
AC 100~240V, 50/60Hz
Fuse:
250V 1A slow blow (20mm glass)
Total Power consumption:
13W
Sound Control:
Internal microphone
DMX connections:
3pin XLR male / female
DMX channels:
1 or 17 channels
DMX starting address:
001
512
Laser Power:
40mW Green CW laser (
λ
= 532nm)
100mW Red CW laser (
λ
= 650nm)
Laser radiation class:
3B
Beam diameter @ aperture:
<5mm
Divergence (each beam)
<2 mrad
Divergence (total output)
<90°
Scanner speed:
15kHz
Working temperature:
10°C to 40°C
Laser Safety Standard:
EN/IEC 60825-1 Ed2, 2007-03
Size:
see picture below
Weight:
1.5kg
Every information is subject to change without prior notice
You can download the latest version of this user manual on our website: www.beglec.com
Summary of Contents for SMOOTH SCAN-3
Page 2: ......
