ENGLISH
OPERATION MANUAL
JB SYSTEMS
®
5/8
LEDCON-XL
FUNCTIONS
(REAR)
20. CHASER CHANNEL MODE:
used to determine if the Led Projector section should work as a 4 or a 8
channel LED light modulator.
21. DMX INPUT:
this input can be used to connect an extra DMX controller to the unit, so you can control
extra DMX channels via the same single DMX line.
The merger function of the unit will automatically add 100 DMX channels to the DMX channel you send
into this input. Like that, the incoming DMX will not interfere with the signals the LEDCON-XL is
generating.
For Example:
Connect a JB Systems SCENEMASTER to the input of the LEDCON-XL
100 DMX channels will be added to the original channels of the SCENEMASTER
This means Channel 001 of the SCENEMASTER will control DMX channel 101 in the DMX line
CH001
CH101
CH002
CH102
CH003
CH103
CH004
CH104
etc.
22. DMX OUTPUT:
Sends DMX-signals to the connected units.
23. AUDIO INPUT:
connect you audio source to
this input to trigger the sound mode programs. If you don’t
connect anything to this input, the internal microphone will trigger the sound mode programs.
24. DC INPUT:
connect the supplied AC/DC adapter to this input. If you should use another adapter, please
make sure that it has a voltage between 9Vdc and 12Vdc and minimum 300mA with + in the center.
25. POWER SWITCH:
used to switch the unit ON/OFF
26. M-DMX OUTPUT:
Please note that this USB-connector is NOT used for updates or to connect the unit to
a PC! Instead this USB-connector makes it very easy to add wireless DMX to the unit! Just add the
(optional) WTR-DMX DONGLE from BRITEQ
®
and you will get wireless DMX! No extra settings to be
made in the setup menu, just follow the procedure in the user manual supplied with the WTR-DMX
DONGLE from BRITEQ
®
.
The separate WTR-DMX DONGLE is available from WWW.BRITEQ-
LIGHTING.COM (order code: 4645)
HOW TO SETUP
1. PROGRAM A SCENE IN THE FADER SECTION, BASED ON THE CHANNEL FADER POSITION:
A.
Scenes can only be programmed while the unit is set in “program mode”. So first enter “program
mode” by pressing the SCENE/MANUAL (4) and PROGRAM (5) buttons together
red “program
LED” is lit.
B.
Use the SCENE/MANUAL butto
n (4) to set the controller to “MANUAL”.
C.
Use the CHANNEL faders (1) to set the desired scene. (scene is present on the DMX-output)
D.
Press the PROGRAM button (5) to check which channel faders already have scenes programmed:
Channel with NO scene programmed: the STATUS LED (3) of this channel is dark.
Channel with scene programmed: the STATUS LED (3) of this channel is lit.
You can save a new scene to an empty channel or overwrite an existing scene.
E.
To program the current scene to a channel fader: keep the PROGRAM button (5) pressed while you
press the FLASH button (2) of that channel fader. (the leds flash 3x to confirm that the scene was
saved)
F.
If you want to program other scenes, just repeat steps C to E.
G.
Press the SCENE/MANUAL (4) and PROGRAM (5) buttons
again to stop “program mode” (the red
“program LED” turns dark)
