Jayco Recon ZX 2011, Owner'S Manual

Page: 80 / 106

SECTION 11
CAMPING & OPERATING
P
OWER
B
UNK
B
ED
W
ITH
R
OLLOVER
S
OFA
(I
F
S
O
E
QUIPPED
)
The electric bed lift operates on 12-volt DC
power supplied by the tow vehicle charge line,
auxiliary batteries, or power converter. The
RV should be hooked up to 120-volt AC
power and have the power converter
operating, if possible.
There are two separate switches used to
operate the bed lift: a backlit master shutoff
switch located near the entry door and a bed
lift “Up/Down” switch located elsewhere in the
trailer.
‰
The master switch must be in the “ON”
position for the “Up/Down” switch to be
operational.
‰
To lower the bed lift, press the “DOWN”
section of the “Up/Down” switch. Lower
the bed to the desired position or until it
automatically stops at its lower limit.
To store the bed, remove any obstacles
laying on the bunk. Press the “UP” section of
the “Up/Down” switch. Raise the bed to the
desired position or until it automatically stops
at its upper limit.
Rollover sofa
To change the bottom bed to the rollover sofa
position, the bed must fully lowered. Grasp
the back section of the bed (closest to the
ramp door area), and pull it upwards towards
Fig. 11.3
Rollover sofa
RAISE THE REAR BED TO THE
HIGHEST POSITION WHEN TOWING
YOUR RV.
Damage to the rear bed may
result from traveling with the bed in the
lowered position.
you. This section will roll over to form the sofa
back cushion.
TV P
OWER
S
UPPLY
DO NOT LOAD MORE THAN 600# ON
THE BED.
Damage to the bed lift
mechanism and personal injury may result
from overloading.
For good station reception, the
TV power supply must be turned
ON to view local television
stations. Turning the TV power
supply ON sends 12-volt DC
through the cable to the TV roof
antenna. The voltage energizes
the transistors in the antenna
head amplifier. The TV signal
then comes down the cable to the outlets.
Fig. 11.4 TV
Power Supply
Turn the TV power supply OFF to view cable
television or to use a VCR or DVD (if so
equipped).
TV A
NTENNA
& C
ABLE
TV
RG-6 coax runs from the TV antenna and
exterior cable TV connector to a wall plate
near the dedicated television space.
The television entertainment system will not
run cable television on one television set and
local stations off the other set without
customer modification. You can either view
local stations or you can view cable television.
TV antenna
To raise the TV antenna to the
operating position turn the
antenna elevating crank
clockwise in the UP direction
until some resistance to turning
is noted.
On amplified models, 12-volt DC power is
required (refer to the OEM
manual). After the antenna is
Fig. 10.4
76