![background image](http://html1.mh-extra.com/html/jayco/recon-zx-2011/recon-zx-2011_owners-manual_3682303048.webp)
SECTION 7
FUEL SYSTEM
The label listed below should be kept
permanently affixed to your RV:
Fig. 7.2 Re-fueling warning label
The RV is equipped with
a master fuel pump
disconnect switch
located on the exterior of
the fuel station. Make
sure this switch is turned
"OFF" when the fuel
station is not in use.
A grounding clip is
attached to the fuel
nozzle. This clip MUST be attached to the
component or vehicle being fueled in order to
ground it to the RV. Do not continue adding
fuel after the fuel pump’s automatic shut off
stops dispensing fuel.
To dispense fuel
Be sure the fuel tank has fuel in it prior to
operating the fuel pump. Ensure the fuel is not
contaminated with debris.
1. Attach
the
grounding clip to
the item or vehicle
being fueled.
2. Pull on the master
fuel pump
disconnect switch
located on the
exterior of the fuel
station to turn it "ON".
3. Turn "ON" the fuel pump with the lever
located on the pump.
4. Insert the nozzle into the receiving tank
and squeeze the nozzle handle.
5. When done, release the nozzle handle to
stop the flow of fuel.
6. Turn "OFF" the fuel pump with the lever
located on the pump.
7. Push in the master fuel pump disconnect
switch to turn it "OFF".
The following warning label should be kept
permanently affixed inside the fuel station
compartment.
Fig. 7.5 Before dispensing fuel label
Fuel filler cap
Fig. 7.3
Do not replace the fuel fill cap with one of a
different type. Use of a substitute cap may
create excessive fuel system pressure,
resulting in fuel station damage and
improper operation in a collision.
Remove the fuel filler cap by slowly turning it
counterclockwise and waiting for any "hiss"
noise to stop. Then unscrew the cap all the
way. To close the fuel filler cap, securely turn
the cap clockwise until you hear clicking
sounds. If you need to replace the fuel tank
filler cap, use only a cap specified for your
RV.
F
UEL
T
ANKS
(
S
)
Fig. 7.4 Grounding clip
DO NOT over fill the factory-installed fuel
tank(s). Follow all safety information in this
manual and the OEM operator’s manual.
Failure to comply could result in death or
serious injury.
44
Summary of Contents for Recon ZX 2011
