SECTION 9
PROPANE SYSTEM
Have the RV checked for leaks at the
connections on the propane system soon
after the purchase and the initial filing of each
propane cylinder. Have the propane system
tested for leakage each time a cylinder is
refilled or after any part of the propane system
has been disconnected.
Use an appropriate propane leak detector
solution or create a soapy water solution. The
propane leak detector solution can be
purchased at most dealerships (if soapy water
is used, make sure that the soap used does
not contain ammonia or chlorine).
Apply the propane leak detector solution to all
propane piping connections. If a leak is
present, the solution will bubble at the
connections. Execute your family safety plan
immediately. After everyone is clear and
accounted for, if possible:
•
Turn off the propane at the cylinder(s).
•
Turn off all appliances that utilize propane.
•
Disconnect the 50 amp power cord.
•
Disconnect the negative auxiliary battery
cables.
•
Turn the generator off.
Always have faulty of damaged propane
components repaired or replaced by your
dealer or certified RV technician before using
your RV again.
DOT
P
ROPANE
C
YLINDER
The propane cylinder is equipped with a
safety valve that relieves excessive
pressure by discharging gas to the
atmosphere. Do not bring or store portable
propane containers(s) or other flammable
liquids inside the RV because a fire or
explosion may result.
Propane is stored in pressurized containers in
a liquid state. As the propane is released from
the container, it changes to vapor that is then
used for the operation of the appliances.
Propane will not run through the appliances in
the liquid state. The volume of liquid propane
increases approximately 1-½% for every 10°F
(5.5°C) it is warmed. Heat the propane 100°F
(55°C) and the container liquid volume will
increase 15%. That is why it is imperative to
leave sufficient space inside the cylinder to
allow for natural expansion of gas during
warmer weather.
The main shut off valve must be kept closed
at all times unless you are using the propane
system or filling the propane cylinder.
When the propane cylinder is disconnected
from the hose, install the valve cover that is
attached so the container. This is required by
the National Fire Protection Agency (NFPA),
other applicable local codes and for your own
safety.
Close the propane cylinder main shut off
valve by hand tightening only
. Use of tools
creates a potential to over tighten the valve
(damaging the interior seals on the cylinder
valve seat). If this type of damage occurs, the
cylinder will not close properly and create a
false sense of security.
DOT propane cylinders must be
transported and stored in an upright
position so the pressure relief device will
function properly. Laying a DOT propane
cylinder on its side may potentially create a
very dangerous situation.
64
Summary of Contents for Recon ZX 2011
