18
NOTE:
Road dirt and grime will sometimes make jacks difficult to operate. You may
need to clean out before operating. To maintain stabilizer jacks keep clean and lubricate
twice a year using only silicone lubricants as oils will attract dirt and cause additional
problems.
Do not place excessive weight on these jacks as they are intended to stabilize, not support
the camper. The camper should be level.
6. Pull end bunk beds out until rail hits bed stop. Distribute awning panel over bunk and
place corners of tent over corner of bed. Again, be sure beds are now extended all the
way out against stops.
7. Place flattened end of straight bed support pole into slot provided on frame of camper.
Support poles are located under the bed. (Fig. 3-7)
8. Now, complete raising roof until gray limit cable is snug. DO NOT OVERTIGHTEN.
(Fig 3-4)
FOR MODELS WITH SLIDEOUT
a. Unlock Slideout. (Fig. 3-5) Lock is located on the outside of the folding camping
trailer. (One exception to this is the Ranier model. This lock is located inside under
the couch.)
b. Pull out slideout using the handle(s) located on the side of the slideout.
CAUTION:
Do not extend slideout before pulling beds out.
NOTE: The slideout rollers may leave slight indentations on the linoleum floor.
c. Lock slideout.
d. Pull bed flaps located on the side of the slideout out over edge and attach to Velcro.
e. Enter unit and set up kitchen flip-top. Attach stove grate.
9. Enter and raise wardrobe and slide to off-door sidewall. Wardrobe will rest against
counter.
10. Insert bed bow support pole at bow peg. Push bow outward and upward while pressing
on button farthest from the end and slip into bracket mounted on roof. Release button.
(Fig. 3-6)
11. Unsnap ties holding door to roof. Rotate turn button located on bottom of door 1/4 turn
to unlock. Swing door down following ceiling track and place bottom of door in floor
track. Insert top of door and hand tighten plastic screws. Lock both barrel locks on each
side of the door.
12. Insert canvas by folding the hard edge of tent over 180º and inserting this portion into
channel of screen door, starting at the bottom. This assures the best possible fit. Attach
Velcro.
13. Flip over flip top.
14. Raise hinged side of flip top and slide leg to “up” position. Rest flip top on top of leg.
15. Raise non-hinged side of flip top. Flip down leg. Leg will rest on top of kitchen counter
with peg seated in hole.
16. Flip dinette seat over.
Summary of Contents for Heritage
