Jayco Heritage, Owner'S Manual

Page: 44 / 87

35
CONVERTER
The converter utilizes 120-volt AC power and transforms this energy into 12-volt DC
power, which is used inside of the camper. 12-volt DC energy supplies power to all
lights, furnace blower, optional water pump.
The converter is a technologically advanced 20-amp PWM “switch mode” type, that can
be used with computers. It is self-contained with a built in circuit breakers and DC fuses.
A quiet cooling fan provides ventilation and is thermally protected to shut down and
cycle back on if overheating occurs.
WARNING:
• Turn off all interior lights before folding the camper for transit as the bulbs
may cause a fire hazard in the folded position and burn holes in tent.
• Do not block converter ventilation.
Interior
All 12-volt power comes from the converter or the black lead in the wire harness from the
tow vehicle battery. Remember, to receive power from the converter you must have a
120-volt energy source available. 120-volt power may be turned off or on by switching
the 120-volt breaker in the converter.
Bunk light will attach to bow support brace with clip on back side of light. To connect
12-volt power, plug single pole connector on recoil wire into receptacle located on each
ceiling light, front and rear. Slide switch to control light is built into light assembly.
A unit with porch light will have the on/off turn button switch built into the light
assembly. A bunk light will attach to the bed bow support brace and on the optional
canopy. When attached to the canopy, the light will be connected to the porch light
receptacle.
Batteries (Optional)
All Jayco folding camping trailers are pre-wired to accept an auxiliary battery if so
desired. The battery must be hooked up directly to red (positive) and white (negative)
wires on trailer hitch, harness and frame using nothing less than 10 gauge wires.
The auxiliary battery may be installed to avoid discharging tow vehicle battery when 110-
volt power is not available.
Camping trailers with power lift system will have a battery and box installed as part of
the option package.
All battery packages installed by the manufacturer will have an “in-line” fuse and holder
included for protection. On power lift system a 30-amp assembly is included and 20-amp
assembly will be used on other camper battery packages.
CAUTION: When drawing current from the tow vehicle battery, be sure to avoid
draining battery to a low point that the tow vehicle will not start.