Jayco Eagle TT 2020, Owner'S Manual

Page: 80 / 201

Section 5: Slideout Systems
78
Norco Slideout Manual Operation
1.
Locate the included flexible shaft in your
owner’s packet.
2.
Attach flexible shaft to the 1/4” hex fitting
on the end of the motor.
3. Attach 1/4” socket & ratchet, or drill to the
other end, and turn in the proper direction to
move the room.
4.
If the cables tighten, and the motor is diffi
-
cult to turn, REVERSE THE DIRECTION.
OVER-TORQUEING CAN HAPPEN,
RESULTING IN SEVERE DAMAGE.
Power Gear Slideout System
Manual Override
- The slideout system is equipped with a manual override that allows you
to extend or retract the room in the event of a loss of power.
If the room does not move when the switch is pressed, check the following:

Make sure the slideout system is turned on.

Battery is fully charged and connected.

Transit bars have been removed (if so equipped).

Always disconnect battery from system prior to manually operating
system. Failure to disconnect battery can cause electricity to back feed
through the motor and cause serious damage to the system as well as void
the warranty

Use EXTREME CAUTION when extending/retracting the room using
the manual override feature. The gears can be stripped out if the room
is manually retracted/extended to its fullest extent and the operator con-
tinues to rotate manual override. Damage can also occur to the slide
components, slide room structure or trim components. Damages due to
misuse of the manual override feature will void any and all claims to the
Limited Warranty.
