Jayco Eagle TT 2020, Owner'S Manual

Page: 111 / 201

Section 7: Fuel & Propane System
109
Be sure to securely re-install DOT cylinder(s) after they have been removed for filling or
replacement. Always close the service valve and install a dust cap or plug when transporting
or storing disconnected containers whether full or empty.
ASME tanks are permanently mounted to the RV and are commonly used on RV mo-
torhomes. The capacity of ASME tanks is expressed in gallons. ASME tanks are filled while
the tank is attached to the motorhome by a qualified propane facility. ASME tanks are
equipped with an automatic stop fill valve designed to reduce the potential of overfilling.
ASME propane tanks are also equipped with a P.O.L. service valve that is for connection of
the supply hose with a left hand threaded brass P.O.L. fitting from the tank service valve to
the two-stage regulator. Not for use on gas grills and other low pressure devices.
Propane is a true gas compressed into a liquid form. As the fuel is released from the con-
tainer, it changes to vapor which is then used for the operation of the appliances. Propane
will not run through the appliances in the liquid state.
Propane expands 1½ percent for every ten degrees of in-
crease in temperature. It is imperative to leave sufficient
space inside the container to allow for natural expansion
of gas during warmer weather.
The main shut off valve must be kept closed at all times
unless you are using the propane system or filling the
propane cylinder. When the cylinder is disconnected
from the hose, install the valve cover that is attached to
the container.
Close the propane cylinder main shut off valve by
hand
tightening only. Use of tools createto over tighten the
valve (damaging the interior seals on the cylinder valve
seat). If this type of damage occurs, the cylinder will not
close properly.
This propane label should be kept permanently affixed
to your RV.
Servicing or Filling
Have the recreation vehicle checked for leaks at the con-
nections on the propane system soon after the purchase and the
initial filling of each propane cylinder.
When you have a new cylinder filled for the first time, make
sure your propane supplier purges your new cylinder of trapped
air. Otherwise, an improper mixture of gas and air will make it
impossible to light your propane appliances.
No one should be inside the RV and only the qualified propane
service technician should be near the RV while the propane tank
is being filled. The new propane container must be carefully
purged for best performance and must
NEVER BE OVER-
NOTE: Tanks are to be installed, fueled and maintained in accor -
dance to State and Local codes, rules, regulations or laws.
“Use propane only” Label
(Canada only)
(label appearance may not
be exact)
“Shut off for re-fueling”
Label
(label appearance may
not be exact)