Jay electronique UR Series, Installation And User Technical Manual

Page: 75 / 140

UR
- 323245J - 75 -
FR EN DE
B1 B2
B3 B4
électronique
électronique
n°1 n°2
n°3 n°4
DATA
électronique
n°1 n°2
n°3 n°4
Fig.3 Fig.1 Fig.2 Fig.4
 
 

key memory URE memory
6.3.4 Procedure: Validation of an electronic key
Reminder :
To use the UR radio remote control system, the identity code contained in the transmitter
memory must match the identity code in the electronic key which is itself identical to that of
the receiver.
If a maintenance transmitter is used or if you change electronic key, the information contained
in the electronic key must be copied in the memory of the transmitter URE.
Conditions for using this procedure :
The configuration of the backup transmitter buttons must be identical to that described in
the electronic key (or the original transmitter).
1- Switch off the receiver
2- Insert the electronic key in the transmitter unit.
3- - Hold buttons n°2 and "On/Horn" pressed, while unlocking the stop palmswitch button
(fig.1).
- Wait until the orange indicator goes off before releasing buttons n°2 and "On/Horn".
The 2 indicator lights on the transmitter URE will flash rapidly.
4- Press the "On/Horn" button to perform automatic programming of the identity code: the
two indicator lights on the transmitter URE go off (fig. 2).
5- The "identity code" information is copied from the electronic key to the transmitter
memory (fig. 3).
6- Exit the programming mode by pressing the stop palmswitch button (fig.4).
The working frequency may need to be programmed (for example, if the new
electronic key is programmed on another frequency).
Perform the procedure described in § 6.3.2.
Apply this procedure when using a maintenance
transmitter or when changing electronic key