Jay electronique UR Series, Installation And User Technical Manual

Page: 72 / 140

- 72 -
UR
- 323245J
FR EN DE
électronique
n°1 n°2
n°3 n°4
électronique
n°1 n°2
n°3 n°4
DATA
électronique
n°1 n°2
n°3 n°4
électronique
n°1 n°2
n°3 n°4
+1
électronique
n°1 n°2
n°3 n°4
+10
électronique
n°1 n°2
n°3 n°4
Fig.1 Fig.2
Fig.4
Fig.3
Fig.5
Fig.6
6.3.2 Procedure : working frequency programming
1- Switch on the URR receiver
2- Insert the electronic key in the transmitter unit.
3- - Hold buttons n°1 and n°2 pressed, while unlocking the stop palmswitch button (fig.1).
- Wait until the orange indicator goes off before releasing buttons n°1 and n°2.
The channel already selected is indicated by two flashing indicator lights on the
transmitter which represent the tens (orange) and units (green).
4- Select the new channel using buttons n°1 and n°2 (fig.2&3).
Press button n°1 to increment the tens and button n°2 to increment the units.
During these operations, the newly selected channel is displayed by the 2 indicator
lights on the transmitter which flash accordingly.
5- Once the desired channel is selected (between 01 and 64), press the "On/Horn" button
to validate your selection (fig.4) :
Briefly pressing "On" :
the transmitter sends the selected channel number to the receiver and saves its new
working channel (fig. 5).
By pressing and holding the "On" button (3 seconds):
the transmitter sends the selected channel number to the receiver (on each of the
radio link channels) and saves its new working channel. Wait until the transmitter
indicator lights no longer flash (around 30 seconds) (fig. 5)
(
this longer procedure is
preferable and should be performed when you are not familiar with the initial working channel of
the receiver
) .
6- Exit the "frequency" programming mode by pressing the stop palmswitch button (fig.6).
7- Check that the receiver has changed channel by performing the startup procedure
detailed in § 6.2.