4
Rev. 1.5
Quick Start
Getting
Started
Operation
Starting to
Print Cards
Cleaning
Trouble
Shooting
Technical
Specifications
General
Information
GETTING STARTED
1.3
Printer installation
The following will guide you through the installation of your J210i/J205 printer.
CAUTION:
Limit AC power supplied to the J210i/J205
Printer to 24 VDC. Limit excess current draw to 16
amps or less, using an associated circuit breaker or
other such device. Never operate the printer in a
location where operator, computer, or printer can get
wet. Personal injury could result. The printer must be
connected to an earthed electrical power supply and
properly protected against electrical surges and
grounding faults. The power supply pack can only be
replaced by the same product from the manufacturer.
1.
Place the printer in a location that allows easy access
to all sides. The printer should never be operated while
resting on its side or upside down.
2.
Place the printer’s power switch in the OFF “O” position.
3.
Insert the power supply to the printer power socket
and attach to a grounded electrical socket of the
proper voltage and type.
4.
Attach interface cable to printer and computer
and then secure.
5.
Switch power on.
CAUTION:
Intermittent or unpredictable operation may
occur from unsecured connectors. If damaged, the
power cable must be replaced by an exact equivalent.
Use only Parallel Cable under 3 Metres in length.
The socket should always be easily accessible to power
off the printer.
