Jaton PowerPro VX, User Manual

Page: 41 / 73

System BIOS
37
On Board FDD Controller:
This is to Enable or Disable the Onboard FDD Controller.
On board Serial Port 1:
This is used to specify the I/O address and IRQ of Serial Port 1. Five options are
available: Disable, 3F8h/IRQ4, 2F8h/IRQ3, 3E8h/IRQ4 or 2E8h/IRQ3.
On board Serial Port 2:
This is used to specify the I/O address and IRQ of Serial Port 2. Five options are
available: Disable, 3F8h/IRQ4, 2F8h/IRQ3, 3E8h/IRQ4 or 2E8h/IRQ3.
On board parallel Port:
Set the I/O address and IRQ of the onboard parallel port. Four options are available:
Disable, 3BCh/IRQ7, 278h/IRQ5 and 378h/IRQ7. Default is 378h/IRQ7.
Parallel Port Mode:
Can be set as EPP v.1.7, EPP v. 1.9, ECP, ECP+EPP 1.7, ECP+EPP 1.9 or
Normal (SPP) mode. Default is Normal (SPP) mode.
ECP Mode Use DMA:
When the mode selected for the onboard parallel port is ECP, the DMA
channel selected can be Channel 1 or Channel 3.
On board IDE-1 Controller:
Onboard PCI IDE 1 controller can be set as Enable or Disable.
Master drive PIO Mode:
Auto: the BIOS can auto-detect the PIO mode of the HDD in order to set
its data transfer rate. (Default)
Mode 0~Mode 4: User can specify the PIO mode of the HDD in order to
set its data transfer rate.
Slave drive PIO Mode:
Auto: the BIOS can auto-detect the PIO mode of the HDD in order to set
its data transfer rate. (Default)
Mode 0~Mode 4: User can specify the PIO mode of the HDD in order to
set its data transfer rate.