Jaton PowerPro VX, User Manual

Page: 12 / 73

Chapter 2
8
Pin number Name or significance of the signal
13 +3VDC
14 Suspend
PN1 - REST (Hardware Reset) switch
There is no specific orientation. Connect the two-thread hardware reset cable to the
PN1 connector pins on the main board.
Pin number Name or significance of signal
15 Hardware reset signal
16 Ground
J1 - AT Power connector
These have a specific orientation. The three warning marks indicate that if you make a
mistake in pin number or connection orientation, you could destroy your equipment.
During installation, you just need to connect to the correct pins and in the correct
orientation, and to connect connector of the power supply unit to the connector on the
main board.
Pin
number
Name of the signal or
signification
Pin
number
Name of the signal or
signification
1 Power Good Signal 7 Ground
2 +5V 8 Ground
3 +12V 9 -5V
4 -12V 10 +5V
5 Ground 11 +5V
6 Ground 12 +5V
I/O Interface
Mouse - PS/2 Mouse connector
There is a 5-pin PS/2 mouse port on the main board. Connect the PS/2 Mouse
connector (included) to the main board. Notice the pin-2 on the 5-pin header does not
have any wire. The PS/2 mouse mini-din connector has an orientation pin. Match the
PS/2 Mouse connector with the mini-din port and plug it in.