Jasic MIG 350C, Operator'S Manual

Page: 11 / 19

the wire feeder to thread the wire through the guide tube,
and into the drive roll groove. Adjust the pressure arm,
ensuring no sliding of the wire. Too high pressure will lead to
wire distortion, which will a
ff ect wire feeding. Press the wire
inch button to thread the wire out of the torch contact tip.
Gas less Self Shielded Welding
Insert the welding torch into the “Euro connector for torch in
MIG” output socket on the front panel of the machine, and
tighten it.
Insert the cable plug with work clamp into the “+” output
terminal on the front panel of the welding machine, and
tighten it clockwise.
Insert the quick plug of the gas / no gas selector into the “-”
output terminal on the middle plate of the welding machine,
and tighten it clockwise.
Install the wire spool on the spindle adapter, ensuring that
the groove size in the feeding position on the drive roll
matches the contact tip size of the welding torch and the
wire size being used. Release the pressure arm of the wire
feeder to thread the wire through the guide tube, and into the
drive roll groove. Adjust the pressure arm, ensuring no
sliding of the wire. Too high pressure will lead to wire
distortion, which will a
ff ect wire feeding. Press the wire inch
button to thread the wire out of the torch contact tip.
10