WWW.JASIC.CO.UK
13
Details of the functional zones on the power supply control panel
Welding mode selection
This area contains components such as welding mode LEDs and
the selecting key. There are 4 welding modes, namely standard
MIG/MAG, pulsed MIG/MAG, Double pulse MIG/MAG and MMA.
Users can select the desired welding mode by pressing the se-
lecting key, and the corresponding LED will be on when a certain
welding mode is selected.
Note: The welding mode LED blinks during welding (when there is
welding current output).
Operating mode selection
This area contains components such as operation mode LEDs and
selecting key. There are 4 operation modes, namely spot welding,
2T, 4T and programmed 4T . Users can select the desired operation
mode by pressing the selecting key, and the corresponding LED will
be on when a certain operation mode is selected.
Note: There are no such function in MMA.
Welding parameter selection
1
Pre-flow time
2
Initial parameters (speed, current and voltage)
3
Upslope time
4
Peak parameters (time, current, speed, thickness, arc
characteristic, voltage, percentage and frequency);
5
Base parameters (current, speed and voltage)
6
Downslope time
7
Crater filling parameters (current, speed and voltage)
8
Post-flow time
Summary of Contents for MIG 350 Pulse Separate
