notice to operators, maintenance
and cleanup personnel
Model JC III
page 3 of 12
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457-4926
UNITED STATES OF AMERICA
TEL. 203-347-7271 FAX. 203-347-6978
6234007::
NOTICE TO OPERATORS, MAINTENANCE AND CLEANUP PERSONNEL
REMOVE ANY MALFUNCTIONING TOOL FROM SERVICE
REPORT ANY PROBLEMS TO YOUR SUPERVISOR
1. Disconnect the air hose in accordance with OSHA’s lockout/tagout procedures (29 CFR 1910.147)
before making any blade changes.
2. Disconnect the air hose in accordance with OSHA’s lockout/tagout procedures (29 CFR 1910.147)
before performing any repairs or maintenance.
3. Disconnect the air hose - or have the air hose disconnected - in accordance with OSHA’s lockout/tagout
procedures (29 CFR 1910.147) before performing any cleanup.
4. Disconnect the air hose when the tool is not in use.
5. Never put fingers, hands or other parts of the body on the cutting edge or within the cutting path of the
tool when it is connected to an air supply.
6. Always wear a cut–resistant glove on the hand that is not operating the tool.
7. Test the tool prior to use daily. Depress the trigger switch and the tool should activate. Release the
trigger switch and the tool should deactivate. If the tool malfunctions, remove it from service and report
or repair it immediately.
8. Never depress the lever switch unless you want to use or test the tool.
9. Never make modifications or alterations to the tool. Report or replace any lost or illegible labels.
