maintenance instructions
Model JC III
page 10 of 12
PRODUCTS CORPORATION
33 ANDERSON ROAD, MIDDLETOWN, CONNECTICUT 06457-4926
UNITED STATES OF AMERICA
TEL. 203-347-7271 FAX. 203-347-6978
6234007::
Fixture “8”
base
top plate
5.4
Insert the small end of the eccentric shaft into the
bottom side of the top plate.
5.4.1 Rotate the eccentric shaft as you lower the top
plate until the upper journal on the eccentric
shaft enters the hole on the bottom side of the
top plate.
5.5
Use the arbor press to push the eccentric journal
into the gear.
5.6
Place gear (item 14) onto fixture ”3” with teeth
facing down.
5.7
Place bearing (item 13) on the large journal of the
eccentric shaft.
5.7.1 The seal on the bearing should face up.
Fixture “1”
Fixture “3”
gear
bearing
seal
5.8
Lightly tap the bearing with the arbor press to ori-
ent it correctly.
5.9
Position the hollow end of fixture “1” over the
small end of the eccentric shaft and press the
bearing fully onto the eccentric shaft.
5.10
Place bearing (item 22) onto fixture “3”.
5.11
Slide bushing (item 21) into the center of the
bearing and, if necessary, press using fixture “1”.
Fixture “1”
Fixture “3”
bearing
bushing
5.12
Slide spacer (item 17) over the eccentric shaft.
5.12.1 The bore on the spacer should face up.
5.13
Slide bearing (item 29) over the eccentric shaft
and into the bore of the spacer.
5.14
Slide upper link assembly (item 19) over the
bearing.
5.15
Slide the lower link assembly (item18) over the
bearing.
5.15.1 The pin on the lower link assembly should face
down.
eccentric shaft
spacer
bearing
upper link
lower link
thrust washer
5.16
Slide thrust washer (item 20) over the eccentric
shaft.
