Japan Radio Co. NKG-84, Instruction Manual

Page: 33 / 100

23
4.5 Stopping the Alarm
If the printer paper runs short.
If the printer paper runs short, an alarm buzzer will sound and the alarm lamp will blink.
▼
Press the ALARM OFF switch.
▼
The alarm buzzer will stop sounding. The alarm lamp will continue blinking.
Supply the printer with paper.
▼
The paper lamp will stop blinking.
4.6 Adjusting The Brightness of Lamps
Press the DIMMER switch.
▼
Each time the switch is pressed, the brightness of the lamps changes in the following order:
High
→ →
Medium
→ →
Low
→ →
Off
Note: The lamp of POWER, the back lamp of POWET swich and the back lamp of ALARM OFF will not be
extinguished even if dimmer off state.
To extinguish the lamps completely, press and hold down the DIMMER switch for more than 5
seconds.However, the PAPER and ALARM lamps will not be extinguished.To adjust the brightness
of the lamps from the state that they are completely extinguished, press the DIMMER switch.
4.7 Turning Power Off
Press and hold the POWET switch for at least two seconds.
▼
The green POWER lamp will go out to indicate that power has been turned off.
POWER
DIMMER
ALARM OFF