47
47
7.40
SCOM. PORT ASSIGNMENT PROGRAMMING
On J3500 two SCOM port (SCOM1,SCOM2) are available like default ; on SCOM1 also the
connector is installed like default (for RS-232), like option can be installed another SCOM
port (SCOM2).
Each SCOM port can be set by the programming described in this page, either for the
type of used protocol than for type of device connect to the SCOM port (PC, Slip Printer,
Scanner, etc...).
These configurations are very usefull, because they allow to use the SCOM port with
the already present connector on ECR (SCOM1), in the necessary mode (Es. Slip
Printer, PC-232, etc...), without for this having to make hardware modification in the
machine.
CONFIGURATION:
P
(95)
X/time
(A BC)
Sub Total
#/NS
KEY
A : Setting code for SCOM1 (from 0 to 6 see table below)
B: Setting code for SCOM2 (from 0 to 6 see table below)
C: Setting code for SCOM3 (from 0 to 6 see table below)
SCOM PORTS SELECTION CODES :
CODE Peripherals(protocol)
0 Not
used
1 Hand
scanner
2 Fix
scanner
3 PC
communication
4 Slip
printer(GP-965)
5
EFT terminal 1
6
EFT terminal 2(for BBS)
Note : - Two same devices cannot coexist connected to the ECR
- Default configuration : SCOM1 =1
SCOM2 =0
7.41
HALO and LALO on OPERATIONS OF VOID AND R.M.
With this function it is possible to define the maximum limit and the minimum limit of
the input amounts on operations of VOID and of R.M.
P
(8)
X/time
(AB CD)
Sub Total
#/NS
KEY
AB : max. limit for operations of VOID and R.M.
A = Max value of the first digit
B = Max digits number
CD
: min. limit for operations of VOID and R.M.
C = Min value of the first digit
D = Min digits number
Summary of Contents for J3500E
Page 55: ...49 49 ...
