Janus POTSwap EVDO910PS, User Manual

Page: 12 / 20

POTSwap User Guide JA16-EVDO-UM Page 12 Rev: P07 Date: 08/01/16
© Copyright 2016 Janus Remote Communications Specifications subject to change without notice
All Rights Reserved See website for latest revision. Not intended for life support applications.
5 External Interfaces continued
CELLULAR (YELLOW) LED:
LED STATUS CELLULAR RADIO
OFF Off
ON Not registered - or - Call active
Blinking 1sec on + 2 sec off Registered in idle
* When the CELLULAR LED stays on (not registered) for more than a few minutes after powering the POTSwap, it is usually an indication of a poor
antenna connection or a problem with the activation on the cellular network. Check that the SIM card is properly installed and that it has valid
activation with a cellular carrier.
STATUS (GREEN) LED
LED STATUS INDICATION
ON Phone line 9RJ11) is OFF-HOOK (also during initialization)
Blinking fast (12.5 Hz) Phone line (RJ11) is ON-HOOK
Blinking slow (1 Hz) Initializing
PUSH BUTTONS
Three push buttons are provided on the front panel of the POTSwap. These can be operated with a small diameter
object such as a paperclip. There is tactile feedback that indicates when the push button has been operated.
Applying pressure to the push buttons beyond the point at which they actuate can damage the switch.
Currently the SELECT and MODE push buttons are not supported. The RESET push button performs the same
function as powering the unit off and then on; the configuration parameters are not affected.
PUSH BUTTON FUNCTIONS
PUSH BUTTON FUNCTION
SELECT Future Use
MODE Future Use
RESET System Restart
PHONE – FXS Connector:
Figure 5 RJ11 Jack
A standard RJ11 jack (6P2C – 6 position 2 conductor) supports the landline telephone interface.
This jack simulates what would be provided by a land-line based telephone central office, including power, ringing
signal and voice transport.
Any standard telephone device can be connected to this connector.
Under no circumstances should the PHONE – FXS connector be connected to
another powered telephone line – e.g. a telephone wall jack or PBX line.