8
►
Attach brackets and guides to jambs using fasteners shown in
Table 1.
►
The guides should be mounted centered about the opening and spaced curtain width + 1" apart, measured from
back of guide to back of guide. Both guides must be plumb.
►
Once both guides have been correctly positioned, attach them to the jambs using the appropriate fastener at each
hole location.
See Table 1.
►
Check top surface of brackets to verify they are level with each other. If they are not, loosen the bracket-to-guide
attachment fasteners and slide bracket(s) vertically until level. Tighten bracket to guide fasteners.
►
Install three (3) bracket-to-jamb attachment fasteners for each bracket.
See Table 1.
TABLE 1: WALL FASTENERS (included for jamb attachment for brackets and guides)
ITEM
JAMB
FASTENERS
DRILL SIZE
BRACKETS
STEEL
3
8
- 16 X 1
1
4
" HEX BOLT AND NUT
7
16
"
BRACKETS
CONCRETE /
FILLED BLOCK
3
8
" X 1
3
4
" WEDGE-BOLT
3
8
"
BRACKETS
WOOD
3
8
- 7 X3" LAG SCREW
-
GUIDES
STEEL
1
4
" X 14 1" TEKS SCREW
-
GUIDES
CONCRETE /
FILLED BLOCK
1
4
" X 1-
3
4
" WEDGE BOLT
1
4
"
GUIDES
WOOD
1
4
X 10 X 2" LAG SCREW
-
STEP 4: GUIDES AND BRACKETS TO JAMB
GUIDE MOUNTINGS ARE DICTATED BY APPLICATION AND JAMB TYPE.
See Pages 9 and 10. for appropriate mounting.
►
STEEL JAMBS:
1/4" - 14 X 1". TEKS SCREW.
SEE PAGE 9 FIGURE 8.
►
MASONRY JAMBS:
1/4" X 1-3/4" WEDGE BOLT.
SEE PAGE 9 FIGURE 9.
►
WOOD JAMBS:
1/4" X 10 X 2" LAG SCREW.
SEE PAGE 9 FIGURE 10.
WARNING!
DOOR CAN FALL IF BOTH BRACKETS ARE NOT SECURELY FASTENED TO THE JAMBS. ALL FASTENERS
ATTACHING BRACKETS TO JAMBS MUST FIT SECURELY INTO A STRUCTURAL MEMBER OR SURFACE. IF
DOOR FALLS, SERIOUS INJURY OR DEATH AND/OR DAMAGE TO DOOR CAN RESULT.
NOTE
: DOOR ASSEMBLES ARE MANUFACTURED PER OPENING WIDTHS AND HEIGHTS SPECIFIED AT TIME OF ORDER. JANUS
INTERNATIONAL WILL NOT ASSUME RESPONSIBILITY FOR OPENING WIDTHS OR HEIGHTS THAT DO NOT MATCH THOSE
SPECIFIED AT TIME OF ORDER.