9
10. Filling of the hopper with dough
Dough can be pushed from the top of the hopper, either in slices, which fit through the
bars, or it can be pushed through the bars into the hopper directly.
You can also open the bars and enter the dough into smaller pieces or slices.
First, the rear kneading rollers (checker, filling, feeding roller) must be covered with
one coat of dough. Only when the roller is completely covered with dough, the machi
-
ne forms perfect figures. Now, push the lever for the knife as far as setting of, until the
figure is truncated at full strength. So the knife cuts the pieces of the dough kneading
roller and passes them onto the upper transport belt.
11. Bring the figures on tray
Now turn the switch from (PERMANENT) to (AUTO) and the machine back on (ON).
The machine is now controlled by the metal contact switch, located under the front
edge of the upper transport belt.
The baking sheets are introduced exclusively from the back of the machine.
The machine turns on by reaching the sensor at the front edge of the upper transport
belt. The figures are now automatically transferred from the upper band to the baking
sheet.
(The following applies only two mechanical switches: If you need to adjust this one,
because, for example, your baking sheets are a little narrow, be sure to hold on the
posterior part of the smooth switching lax a finger against the switch before you turn
the switching lax!)
12. One-man operation
If the tray is full, the machine is switched off with the switch contact plate. This gives
you a chance to remove the sheet and to introduce an new sheet into the machine wit
-
hout needing an extra person. If you are working with several people at the machine, it
may be useful to switch the machine on (PERMANENT). Don´t forget to refill dough in
time. There should always be dough for only 2 to 3 sheets in the hopper, that means,
the space between the kneading roller and the grid should be half full.
13. Distances on the baking sheet
For very soft dough, it is possible that the figures push together on the knife. Ne
-
vertheless, to achieve an optimal assignment sheet, change the speed of the lower
transport belt and proceed as described in 4.
