13
X
Y
X ≈ X
Y < X
Automatic operation B) –
Automatic sheet filling with specification of the
cookie rows:
This function should preferably be selected when
the spacing of the cookie rows on the sheet should
not be too large and therefore smaller than the
spacing of the rows of shapes
on the pattern roller.
This could be the case for special shapes which,
due to technical reasons, cannot be engraved on
the roller circumference optimally, e.g. a large
St. Nickolaus with a length of over 14 cm. This can
only be engraved on the roller circumference (393 mm) twice. With Permanent, there
would be a large gap between the rows of shapes on the baking sheet.
Here, the automatic function offers the option of reducing the spacing on the sheet to
achieve a better utilisation of the surface of the baking sheet (see the figure).
In automatic operation, you can now enter the desired number and spacing of the
rows of shapes on the sheet (trial and error! – it depends on sheet speed and sheet
length).
1) Set the number N of the cookie rows on the sheet:
To do so, press the mode button (4) until LED (9)
in the mode field below lights up.
Then press the arrow button (10) until the desired
number of cookie rows (e.g. 8) on the sheet is shown on
the display.
2) Set the spacing <-> of the cookie rows relative
to each other on the sheet:
To do so, press the mode button (4) until
LED (8) below lights up.
Then press the arrow button (10, 12) until
the desired spacing of the cookie rows on the baking sheet is
shown on the display (11).
The spacing must be set using repeated trials.
3) Now press button (2) for automatic operation
(the upper LED on the button will light up).
Inserting the baking sheet causes the machine to start.
Adjusting the sheet speed V
3
The sheet speed V
3
can be set either faster or slower relative to the speed of the
upper conveyor belt (this can also be done during operation).
1) To do so, press the mode button (4) until LED (7) below lights up. Then press the
arrow button (10, 12) until the desired speed of the sheet transport belts is shown on
the display (11).
