Janome Skyline S9, Instruction Book

Page: 146 / 182

144
Lace Design RE20a-1 (Designs for water soluble
stabilizer)
You can attach up to 4 flower designs to the large lace
design (Designs for water soluble stabilizer) RE20a-1.
z
Prepare the flower designs you want to attach before
sewing the lace design RE20a-1. Select the desired
flower designs from the “Designs for water soluble
stabilizer” category, and sew them to the water soluble
stabilizer. Remove the water stabilizer by soaking the
flower designs into a bowl of warm water.
x
Draw centerlines on the water soluble stabilizer with
tailor’s chalk. Set the water soluble stabilizer in the
hoop RE20a and attach the hoop to the carriage.
Select the RE20a-1 design (Designs for water soluble
stabilizer).
c
Sew until the 11th section (color). The 11th section is
the placement guide for placing flower designs.
Place one of the flower design pieces which was
created in procedure
z
above so that the flower
design is aligned with the placement guide.
x
z
c
v v
Use tape to hold the design for your convenience.
Sew the 12th section (color) over the design. The
flower design is attached to the large lace RE20a-1
design.
b
Sew the rest of the sections. The 13th, 15th and 17th
sections are the placement guides. Place the flower
designs created in procedure
z
and sew over flower
designs (same as done in procedure
v
).
Remove the design from the hoop.
Remove the water stabilizer by soaking the overall
design into a bowl of warm water to complete the
design.
b