Janome Memory Craft 6700P, Instruction Book

Page: 22 / 112

20
c
Winding the bobbin
NOTE:
You can adjust the bobbin winding speed (refer to
page 35).
z
Raise the retractable thread guide bar.
Pass the thread through the guide on the thread guide
bar from behind.
q
Thread guide bar
x
Pass the thread under the bobbin winding tension
disk.
w
Bobbin winding tension disk
e
r
c
Thread through the hole in the bobbin from the inside
to the outside.
Put the bobbin on the bobbin winder spindle.
Push the bobbin winder stopper to the left.
e
Bobbin winder spindle
r
Bobbin winder stopper
x
w
q
z
v
Hold the free end of the thread in your hand
and press the bobbin winding key.
Press the bobbin winding key again to stop
the bobbin when it has wound several layers,
and cut the thread close to the hole in the
bobbin.
t
Bobbin winding key
v
t
NOTE:
When the bobbin winding key is pushed without
pushing the bobbin winder stopper to the left, the
screen shown left is displayed.
Push the bobbin winder stopper to the left before the
winding.
b
Press the bobbin winding key again. When the bobbin
is fully wound, the machine will stop automatically.
The bobbin winder stopper automatically returns to its
original position. Cut the thread.
y
Thread cutter
NOTE:
For safety purposes, the machine will automatically
stop 1.5 minutes after starting bobbin winding.
b
y