Janome Memory Craft 6700P, Instruction Book

Page: 21 / 112

19
Bobbin winding while working on a sewing project
There are 2 spool pins on the spool stand.
You can use both spool pins when you need to wind a
bobbin without unthreading the machine while working on
a sewing project.
Place a spool of thread on the spool pin and fix the spool
with the spool holder as shown.
NOTE:
Those spool pins are also used for twin needle sewing
(refer to page 80).
Setting the spool of thread or thread cone (special
size)
Use the spool holder (special) to hold the specific size of
the spool of threads as shown.
The sizes of the spools of thread are as follows;
The hole diameter of the spool has a range of 3/8˝ to
7/16˝ (9.5 to 10.5 mm)), and the spool length has a range
of 2 3/4˝ to 3˝ (70 to 75 mm).
o
Spool holder (special)
!0
Hole diameter (3/8˝ to 7/16˝)
!1
Spool length (2 3/4˝ to 3˝)
Firmly insert the spool holder (special) into the hole and
hold the spool as illustrated.
!0 !0
!1
o