(A)
(B)
Main
Slave
DC1
BH Sensor
H
X
Adjusting Buttonhole Lever
To adjust buttonhole lever:
1. Start up the machine in Adjust Mode. Turn the power
switch on while pressing the Start/Stop button and the
reverse button at the same time. (Keep pressing both
buttons until the LCD screen shows the adjusting
window.)
2. Press the BH Sensor key on the touch panel.
3. Loosen screw (A) and move the buttonhole lever guide
(1), so that the screen shows “L” when the buttonhole
lever (2) is lowered. Then tighten screw (A).
4. Attach the BH foot (R) and lower the BH lever (2).
5. Insert a 1.6 mm thickness gauge (3) between the
slider and the spring holder to set the space at 1.6 mm.
6. Loosen the screw (B) until the touch panel shows “H”.
7. Twist the screw in until the screen indication changes
from “H” to “L”.
8. Press the X key and turn the power switch off.
(1) Buttonhole lever guide
(2) Buttonhole lever
(3) Clearance (should be 1.6 mm)
(1)
(2)
(3)
33
(Thickness of the Gauge 860G002)
1.6 mm
www.promelectroavtomat.ru
