(A)
(B)
(C)
(D)
Adjusting Feed Dog Height
When the pressure adjusting dial is set at “3” and the presser foot is lowered, the highest
position of the feed dog should be 0.80 to 0.90 mm from the surface of the needle plate.
To adjust feed dog height
1. Remove the extension table, bed cover and thread
cutter cover.
2. Set the pressure dial at 3 and lower the presser bar
lifter, then turn the power switch on.
3. Turn the handwheel toward you until the feed dog
comes to its highest position.
4. Loosen the screw (A).
5. Loosen the nut (1) and adjust the feed dog height to
0.8 to 0.90 mm (4) by turning the adjusting screw (B).
6. Tighten the nut (1).
7. Tighten the screw (A).
To adjust the feed dog position parallel to
needle plate
Turn the handwheel toward you until the feed dog
comes to its highest position. The feed dog (3) and the
needle plate should be parallel. If not, follow the
instructions below.
1. Insert the hexagonal socket screw (C) into the
threaded hole (6) and screw it in until the tip
of screw reaches the bottom.
2. Loosen the screw (D).
3. Turn the hexagonal socket screw (C, part No.
000111108, 2 mm blade) and adjust the feed dog (3)
to be parallel to the needle plate.
4. Tighten the screw (D).
5. Remove the hexagonal socket screw (C).
6. Reattach the thread cutter cover, bed cover and
extension table.
(1)
(2)
(3)
(4)
(5)
(6)
23
0.8 mm
(Thickness of the
gauge 860G002)
www.promelectroavtomat.ru