Janome HD3000, Instruction Book

Page: 8 / 48

4
SECTION II
GETTING READY TO SEW
Foot Control
Connecting the Machine to the Power Supply
Before connecting the power, make sure the voltage
and frequency of your electrical power conform to the
machine.
Switch off the power, fit the nonreversible plug into the
machine socket and plug the machine into the power
supply.
Switch on the power.
While in operation, always keep your eyes on the
sewing area, and do not touch any moving parts such
as the thread take-up lever, handwheel or needle.
Always turn off the power switch and unplug from the
power supply:
- when leaving the machine unattended.
- when attaching or removing parts.
- when cleaning the machine.
Do not place anything on the foot control, otherwise
the machine will run intermittently.
Operating Instructions:
The symbol “O” of a switch indicates the “off” position
of a switch.
For an appliance with a polarized plug (one blade
wider than the other):
To reduce the risk of electrical shock, this plug is
intended to fit in a polarized outlet only one way.
If it does not fit fully in the outlet, reverse the plug. If it
still does not fit,
contact a qualified electrician to install the proper
outlet.
Do not modify the plug in any way.
The foot controller Model YC-482J or TJC-150 is used
with this sewing machine (USA market only).
Sewing speed can be varied by the foot control.
The harder you press on the control, the faster the
machine runs.