janitza UMG 96 RM-EL, Operating Instructions And Technical Data

Page: 30 / 92

30
UMG 96RM-EL
Operation
The UMG 96RM-EL is operated via buttons 1 and 2 with
the following functions:
• briefly pressing button 1 and 2:
next step (+1)
• pressing and holding button 1 and 2:
previous step (-1)
Measured values and programming data are displayed
on an LCD display.
There are display and programming modes. You can
avoid an unintentional change of programming data
by entering a password.
Display mode
In display mode, you can scroll through the programmed
measured values by pressing buttons 1 and 2. When
the device is delivered, all measured value indications
of profile 1 can be retrieved. For each measured value,
up to three measured values are indicated. The measured
value rotation can display selected measured value indi-
cations one after the other with a selectable changing
time.
Programming mode
You can view and change the necessary settings
of the UMG 96RM-EL in programming mode. Press but-
ton 1 and 2 simultaneously for about 1 second to switch
to programming mode after entering the password. If no
password is programmed, you get directly to the pro-
gramming mode menu. Programming mode is marked
by the text „PRG“ on the display.
Press button 2 to switch between the following menus:
- Current transformer,
- Voltage transformer,
- Parameter list,
- TCP/IP device address,
- Subnet mask,
- Gateway address,
- Dynamic TCP/IP addressing (in/out).
If no button was pressed for about 60 seconds when you
are in programming mode, or button 1 and 2 are pressed
simultaneously for about 1 second, the UMG 96RM-EL
will switch back to display mode.