janitza UMG 96 RM-EL, Operating Instructions And Technical Data

Page: 92 / 92

92
UMG 96RM-EL
TCP/IP addressing quick guide
Manual TCP/IP settings
Switch to the programming mode:
• Press button 1 and 2 simultaneously for around 1 se-
cond to switch to the programming mode. The sym-
bols for the programming mode PRG and the current
transformer mode CT appear on the display.
Adjust the TCP/IP address (Adr.)
• Press button 2 to select "Adr"
• Press button 1 to enable the first digit (byte 0)
of the address (digit is flashing). Press button 2 to set
the digit.
• Press button 1 to select the next digit (flashing) and set
the desired digit by pressing button 2.
• If byte is set to 0, the address can be set from 1 to 3
by pressing button 1. Then the display jumps back
to Byte 0 (
no digit is flashing).
Subnet mask (SUb)
• Press button 2 to select the subnet mask and set it
in a manner similar to adjusting the address by pres-
sing button 1 and 2.
Adjusting the gateway address (GAt)
• Use button 2 and 1 to set the gateway in a manner
similar to adjusting the address.
Deactivate dynamic IP allocation (cf. page 41)
• Set the parameter „dYn IP“ to the „Fixed IP address“
mode
Exit programming mode
Description
Byte identification
(e.g. byte 0) of the address
Address data, byte 0
Fig. TCP/IP address, byte 1
A TCP / IP address consists of 4
bytes with the following structure:
xxx.xxx.xxx.xxx
Byte 1 Byte 0 Byte 2 Byte 3
• Press button 1 and 2 simultaneously to exit the mode
or wait 60 seconds.
Activate/deactivate dynamic IP allocation (dyn)
Device/gateway address and subnet mask are assig-
ned by a DHCP server and enable automatic integration
of the device into the existing mains.
• When in programming mode, press button 2 repea-
tedly to display the tab labelled „dYn IP“ and activate
the parameter with button 1.
• Select the parameter digit with button 1 and set the
value (e.g. 000=fixed IP address, 002 = Activated
DHCP mode) with button 2.
• Exit programming mode.